| 1. | Equal strain solutions of radial and vertical coupled consolidation by vertical drains under arbitrarily distributed ground soil stress increase
任意附加应力下竖井径竖向耦合固结等应变解 |
| 2. | But the stress increase due to bottom material visco - elasticity is small in the model of this paper
但在本文设定的构造模型框架和介质参数下，下层黏弹性的存在对上层母体的应力随时间的增加影响不大。 |
| 3. | Residual stresses of bst thin films are tensile stresses , grain size and stresses increase with annealing temperature
Bst薄膜残余应力表现为张应力且随着薄膜晶化温度升高,薄膜的晶粒变大,残余应力呈变大的趋势。 |
| 4. | When the recovery stress is low , the stress increase sharply along with heating , and dependence of the stress on the temperature is approximately linear
当回复力较低时，回复力随温度快速上升，呈近似线性关系。 |
| 5. | The flow stress increases with decreasing deformation temperature and increasing of strain rate . the stress is sensitive to strain rate positively
稳态流变应力随变形温度的降低和应变速率的升高而增大，具有正应变速率敏感性。 |
| 6. | 4 . the stress increaseing rule of external prestressing tendon is studied and analyzed . simple calculation method of stress increment of external prestressing tendon is put forward
研究并分析了体外预应力筋的应力增长规律，提出了计算预应力筋应力增量的简便方法。 |
| 7. | Five prestressed concrete testing beams were designed with different reinforcing distance . based on experiments of frp prestressed concrete beams , failure pattern 、 load - deflectioncurve 、 stress increasing and so on are studied systematically
设计了五根不同加固距离的试验梁,对试验梁的受力过程、破坏形态、荷载-挠度曲线、纤维筋应力增量等进行了详细分析。 |
| 8. | Thermal analysis of the adhesive was performed to identify the incomplete cure of the adhesive after first curing process and the penetration of moisture into the package is the main reason for sharp stress increase
运用tga 、 dta等热分析手段对粘合剂的固化过程和再固化过程进行了研究，并对实验中的应力突变的机理进行探讨，认为水汽是导致应力突变的主要原因。 |
| 9. | At last , the application of mechano - electric effect on smart concrete structures is discussed . the following conclusions can be obtained : ( 1 ) the stress induced electrical current increases with stress increasing , and decreases with stress decreasing
取得了如下成果： ( 1 )揭示了碳纤维混凝土和素混凝土所受载荷和由此产生的电流强度之间的一一对应关系。 |
| 10. | The less the lattice friction is , the longer time the dislocated emission keeps . the size of dfz and the morphology of pile - up dislocations would change during the crack propagation . the length of dfz increased as applied stress increased
在保持恒位移过程中，裂尖位错发射与运动还会持续进行一段时间，位错运动的点阵阻力越小，位错发射与运动持续的时间越长。 |
